| VigorSwitch G1282
Physical Interfaces
|
24 RJ-45 Ethernet Ports – 10/100/1000Mbps |
| |
Factory Reset Button |
| |
4 Selectable Ports (Nos. 25-28), use as either: |
| |
10/100/1000BaseT (Gigabit) Ethernet |
| |
or SFP (1000M) Ports for Uplink / Fibre |
| VLAN |
802.1q Tag-based VLAN |
| |
Port-based & MAC-based VLANs |
| |
Up to 255 VLANs (out of 4096 VLAN IDs) |
| |
Voice VLAN (OUI Mode) |
| |
Surveillance VLAN (OUI Mode) |
| |
Management VLAN |
| |
Port Isolation (Protected Ports) |
| QoS |
Support 8 priority queues |
| |
Port-Based rate control (Ingress & Egress) |
| |
Priority queue schedule (WRR or Strict Priority) |
| |
Rate Limit |
| |
Class of Service |
| |
802.1p CoS |
| |
DSCP |
| |
CoS-DSCP |
| |
IP Precedence ToS |
| Network Security |
IP Source Guard with ARP inspection |
| |
IP Conflict Prevention |
| |
Storm Control (Broadcast, Unknown Multicast, Unknown Unicast) |
| |
DoS Attack protection |
| |
Protected Port / Port Isolation |
| |
Static Port Security |
| |
Loop Detection & Prevention |
| |
Access Control Lists (ACL) |
| |
Up to 512 ACL Entries |
| |
Source and destination MAC |
| |
VLAN ID |
| |
IPv4/v6 address |
| |
Protocol |
| |
TCP/UDP port |
| Spanning Tree |
Spanning Tree Protocol (STP) |
| |
Rapid Spanning Tree Protocol (RSTP) |
| Link Aggregation |
Combine multiple ports to increase bandwidth |
| |
8 Aggregation Groups |
| |
Up to 8 ports in each group |
| |
LACP or Static setup |
| |
Supports traffic load balancing |
| Networking Performance |
Switching Capacity: 56Gbps |
| |
Forwarding Rate: 41.7Mpps (64 bytes) |
| |
Jumbo Frames up to 9KB |
| |
Packet Buffer size: 4.1Mbit |
| |
MAC Address Table: 8000 entries |
| Multicast |
Up to 256 multicast groups |
| |
Multicast Group Filtering / Throttling |
| |
IGMP Snooping V2/V3 (BISS) |
| |
IGMP V2/V3 Querier |
| |
Multicast VLAN registration |
| ONVIF Surveillance Management |
Discovery of ONVIF-compliant IP Cameras |
| |
Surveillance Topology |
| |
Real-Time Video Streaming |
| |
ONVIF Device Maintenance |
| |
Device Information |
| |
Network Settings Configuration |
| |
Time Settings |
| |
Reboot |
| |
Reset to Factory Default Settings |
| |
Ping Check with Mail Alert on disconnection |
| Management |
Central Management |
| |
VigorACS |
| |
VigorConnect |
| |
Vigor Router Switch Management |
| |
(requires router firmware support) |
| |
IPv4 & IPv6 Dual-Stack |
| |
Web User Interface |
| |
Firmware Upgrade/Backup |
| |
Configuration Backup/Restore |
| |
Factory Default |
| |
System Reboot |
| |
2-level Admin Privileges |
| |
Multiple Admin Accounts |
| |
Command Line Interface (CLI) via SSH/Telnet |
| |
OpenVPN Client with Certificate-based auth |
| |
SNMP v1, v2c, v3 (with Generic Traps) |
| |
SNTP (Simple Network Time Protocol) |
| |
LLDP(802.1ab) + MED |
| Diagnostics |
Port Status & Usage display |
| |
CPU/RAM Usage display |
| |
MAC Address Table |
| |
Device Check |
| |
Syslog |
| |
Mail Alert |
| |
Port Status |
| |
Port Speed Change |
| |
System Restart |
| |
Device Check |
| |
IP Conflict |
| |
ONVIF IP Camera Snapshot |
| |
Port Mirroring |
| |
Ping Diagnostics |
| |
Port-based Cable Test |
| IPv4 Features |
DHCP Client |
| |
DNS Client |
| IPv6 Features |
Auto Configuration |
| |
Static IPv6 Address & Prefix Length |
| |
Static IPv6 Default Gateway |
| |
IPv6 Neighbour Discovery (ND) |
| |
IPv6 Duplicate Address Detection |
| |
ICMPv6 |
| |
DHCPv6 Client |
| General IEEE Standards Compliance |
802.3 10Base-T |
| |
802.3u 100Base-T |
| |
802.3ab 1000Base-T |
| |
802.3x Flow Control |
| |
802.3 Auto-Negotiation |
| |
802.1q Tag-based VLAN |
| |
802.1p Class of Service |
| |
802.1d STP |
| |
802.1w RSTP |
| |
802.3ad LACP |
| |
802.1AB LLDP |
| |
802.3az EEE |
| Operating Requirements |
Power Input Requirements: 100-240VAC |
| |
Power supply: Internal |
| |
Maximum Input Power Consumption: 36 Watts |
| |
Cooling: Passively cooled, no fan |
| |
Operating Temperature: 0 °C to 50 °C |
| |
Storage Temperature: -20 °C to 70 °C |
| |
Operating Humidity: 10% to 90% RH (non-condensing) |
| Physical Specifications |
Dimensions: 441 x 206 x 44 mm (W x D x H) |
| |
Rack mountable: 1U |
| |
Weight: 2.8 Kg |
| Box Contents |
VigorSwitch G1282 Network Switch |
| |
UK IEC13 Power Cable |
| |
1U Rack Mount Fittings |
| |
Quick Start Guide |
| ROHS & CE Compliant |
|
| Warranty |
Two (2) Year Manufacturer’s RTB |
| |
VigorCare C3 3 Year Subscription: VCARE-C3 |
| |
VigorCare C5 5 Year Subscription: VCARE-C5 |
